Pronterface execution of skeinforge failed

Hello all,
As a newby, i can not get my skeinforge running in pronterface.
After downloading and installing (from mendel-parts) I have checked and specified my defaults.
When loading an STL in Pronterface, it gives this error:

Skeinforge execution failed
Followed by a file path and the remark : Import error, No module named skeinforge_application.skeinforge_utilities


So probably I have a flaw in my install or ...?

Help advice appreciated,
Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Same problems!

Run skeinforge from command line instead, it works much better!

i think there is some problem with path names etc...

I'm pretty sure you can set what command line pronterface executes, in pronterface's settings.

Replace Wrote:
-------------------------------------------------------
> Hello all,
> As a newby, i can not get my skeinforge running in
> pronterface.
> After downloading and installing (from
> mendel-parts) I have checked and specified my
> defaults.
> When loading an STL in Pronterface, it gives this
> error:
>
> Skeinforge execution failed
> Followed by a file path and the remark : Import
> error, No module named
> skeinforge_application.skeinforge_utilities
>
>
> So probably I have a flaw in my install or ...?
>
> Help advice appreciated,
> Thomas