Welcome! Log In Create A New Profile

Advanced

Ultigcode tool change help needed.

Posted by xile6 
Ultigcode tool change help needed.
March 18, 2017 09:35AM
Not sure if this is the right place for this thread

Looking for a little help.
I am using cura 2.4 and utligcode.
I am setting up a dual extrusion with single hot end. (Y adapter before the hotend)
I am looking for the settings to add a script when the tool changes.
What i am needing is this.

When it goes from T0 to T1, I need it to retract X amount of filament of T0, then switch to T1 and extruder X amount of filament before it starts to print.
And the same when switching back to T0.

I have been unable to find this setting in cura.
Does anyone know where it is at? Or does it happen to be in the firmware?


Any help or links would be grear thank you.
Sorry, only registered users may post in this forum.

Click here to login