Not sure if this is the right place for this thread
Looking for a little help.
I am using cura 2.4 and utligcode.
I am setting up a dual extrusion with single hot end. (Y adapter before the hotend)
I am looking for the settings to add a script when the tool changes.
What i am needing is this.
When it goes from T0 to T1, I need it to retract X amount of filament of T0, then switch to T1 and extruder X amount of filament before it starts to print.
And the same when switching back to T0.
I have been unable to find this setting in cura.
Does anyone know where it is at? Or does it happen to be in the firmware?