So finally i after some adversity, i've put my printer together
, and all the axises moved impeccably and heaters worked separately just fine. then when i just wanted to print out a test piece, the i got an error, that may heater failed: ID bed. after a restart same thing but with the extruder.
and after yet another restart, i got the extruder to finally reach the target temp, but immediately after that it started to drop, even though the message on that blue background above the manual control tab says ''heating extruder''. and after that as soon as i restart it say ''processing'', and nothing happens
has anyone dealt with this and could walk me through this problem?