Welcome! Log In Create A New Profile


Help X axis stops

Posted by Chaparro1973 
Help X axis stops
December 20, 2016 02:49AM
I have the following setup

Board : GT2560 (also tryed with ramps, but the same)


DRV8825 for x, y, and z axis

A4988 for the extruder

Firmware Marlin and repetier

Everything is working fine until i star printing, after a few layers (usualy 3 or 4 layers) the x axis just stops, and even if i reset the board wont move.

The only way it gets working agains is if i unplug everything and start over.

Checked voltage on the drivers and endstops and it seams ok just before starting to print.

Can someone give me a hand please?
Sorry, only registered users may post in this forum.

Click here to login