Welcome! Log In Create A New Profile

Advanced

Good 3d slicer and printing help

Posted by gorgtallisman 
Good 3d slicer and printing help
April 17, 2017 11:15PM
Can someone lead me to a good slicing and printing software I have been using repetier but it keeps misalignment the layers as it prints. I know my bed is level, all belts are tight and im running it at the slowest speeds so I am guessing its the software ??
Re: Good 3d slicer and printing help
April 19, 2017 05:58PM
No, your pulleys can be slipping on the motor shaft, the stepper current could be too low, feedrate too high. there are a number of issues that cause skipping steps software would be last on the list
Sorry, only registered users may post in this forum.

Click here to login