Hi.. Topic says all.. I have problem with this feature, I made my own solution (with MK8 extruder) with servo and micro switch. After couple of firmware editing and tuning I have auto bed leveling. Before printing I go to home point (G28), then G29 for auto level, then G28 X0 Y0 (If I don't do this, all objects are printed with offset). Print starts, but Z motors only move when changing layer
The bed is not right leveled. I'm using Marlin 1.0.2. Please, do you have any suggestions? I spent two days with it without success
Thanks
Tom
Edited 1 time(s). Last edit at 08/01/2016 01:11AM by pospa.