Two days ago I acquired a Prusa i3 3D printer for Christmas.
I assembled it quickly, and turned it on and found no problems.
I tried to print something, but I found that since the hotbed was not heated, the PLA would not stick to the board for the first layer.
I think it is a problem with the port since when I placed the wires for the hotbed in to to wires for the nozzle, and the hotbed heated perfectly fine.
I have no clue how to go about fixing this problem and could really use some assistance.
By the way, the LCD screen says 0/0 by default, and when I try to preheat the hotbed, it turns to 0/70, but the temperature does not change.
I fumbled around with the wires and got a MINTEMP error, but when I reset the machine the error went away.