ok so this will be my first 3d printer, and I am planing to buy the "Prusa Mendel i2 Kit (No Plastics)" from easyreprap.com and I wound like to verify the 3d plastics part I need to buy, I would like to buy then all at the same time.
so I will need
8 bar clamp from the metric-prusa-lm8uu folder
3 bearing-guide from the metric-prusa-lm8uu folder
4 belt-clamp from the metric-prusa-lm8uu folder
4 belt-clamp-nut-holder from the metric-prusa-lm8uu folder
2 coupling from the metric-prusa-lm8uu folder
3 endstop-holder from the metric-prusa-lm8uu folder
2 frame-vertex from the metric-prusa-lm8uu folder
4 frame-vertex-foot from the metric-prusa-lm8uu folder
2 rod-clamp from the metric-prusa-lm8uu folder
1 x-carriage from the metric-prusa-lm8uu folder
1 x-end-idler from the metric-prusa-lm8uu folder
1 x-end-motor from the metric-prusa-lm8uu folder
1 ybrac-t from the metric-prusa-lm8uu folder
3 y-bushing from the metric-prusa-lm8uu folder
2 z-motor-mount from the metric-prusa-lm8uu folder
then I need to run the generate-metric-prusa-lm8uu.sh to get the rest of the stl file that I will need.
Do all of this sound like all of the part I will need, am I missing anything. or is that all of the plastics part I will need to build the 3d printer.