thingiverse
http://reprap.org/wiki/Air_2
I'm not sure why I did it, but I bought a lasercut aluminium frame for an air2 printer - it was an ebay bargain
(A bargain that will cost me a few hundred quid to make a printer I don't really need - oh well)
Has anyone built one - modified it - any tips?
I think the design maybe could be improved on.
Mount the motors to the bottom to bring the C of G down?
Mods. to the Y axis/ bed to enable 3 point levelling without losing build height?
You don't hear much about them, maybe there is a reason for that.
I believe user
Ohmarinus has one but I haven't seen him around here lately.
Any thoughts? Good or bad, please share them
Ta.
-a
Edit: This printer uses printed parts that fit the Prusa Mendel.I'm sure these have evolved and there are a few variations about.
Any suggestions on best latest thinking would be welcome.
Also, I bought some flanged brass bushes with an 8mm bore/ 10.9 od which I intend to use. If someone has scadded up Mendel X and Z axis parts to suit, let me know!
Thanks.
-a
Edited 1 time(s). Last edit at 06/16/2015 08:27AM by alan richard.