Hi folks,
I have a J Head mk V and a Prusa i3 with a Greg's extruder.
It looks like the hotend is just supposed to be a press fit, sliding into the notch on this part:
[
www.reprap.org]
However, my hot end is super loose, and can wiggle around quite a bit,
even though the actual slide area is a tight fit. I have tried tightening down the extruder on top of the hot end too, but this hasn't helped.
Is there a design that allows me to clamp down the hot end with a bolt or something? I'm not liking this press fit design at all.
Or, if you have any other ideas I would be interested to hear them.
Thanks!