Welcome! Log In Create A New Profile

Help

firefightervince

Help
November 14, 2014 09:26PM

Registered: 9 years ago
Posts: 8

Motor wiring on the Pursa I3. It shows Red Grey Yellow Green on the info I got with the printer, but the pre wired connections on the motor show red, yellow, grey, green, and is the Red wire pointed down or up?

Edited 3 time(s). Last edit at 11/15/2014 12:06AM by firefightervince.

Reply Quote

AbuMaia

Re: Help
November 14, 2014 10:10PM

Registered: 10 years ago
Posts: 167

You need to give us more information so we can help you.

MakerFarm 8" Prusa i3v
RAMPS 1.4
0.4mm E3D v6 for 1.75mm

Reply Quote

firefightervince

Re: Help
November 14, 2014 10:29PM

Registered: 9 years ago
Posts: 8

Edited pictures

Edited 2 time(s). Last edit at 11/15/2014 12:07AM by firefightervince.

Reply Quote

Attachments:
open | download - 1phpb0y01aPM.jpg (11.6 KB)
open | download - 2php1yKuWJPM.jpg (29.4 KB)

firefightervince

Re: Help
November 14, 2014 10:30PM

Registered: 9 years ago
Posts: 8

Edited Thanks

Edited 1 time(s). Last edit at 11/14/2014 11:58PM by firefightervince.

Reply Quote

firefightervince

Re: Help
November 14, 2014 11:57PM

Registered: 9 years ago
Posts: 8

Edited

Edited 1 time(s). Last edit at 11/15/2014 12:07AM by firefightervince.

Reply Quote

SteveRoy

Re: Help
November 15, 2014 07:29PM

Registered: 10 years ago
Posts: 477

If you aren't sure about the pairs then use a multi meter, very low or no resistance/short will show a pair, open circuit won't.
As for the wiring, you can just reverse/flip the connector on the RAMPS or change the firmware.

Steve

My updated Instructable on our Prusa i3 Build
[www.instructables.com]

Reply Quote

firefightervince

Re: Help
November 16, 2014 01:24AM

Registered: 9 years ago
Posts: 8

Thanks, it seems like it just shakes a little and does not move. I will pick a multi meter up

Reply Quote

firefightervince

Re: Help
November 16, 2014 11:06AM

Registered: 9 years ago
Posts: 8

I got it working better, but now with Ponterface if I move + on Y X Z its so slow small movements on .01 to 100, but on any - with X Y Z its super fast? Thank you so much for the help btw