Hey,
So finally managed to get my printer working well and printing like a trooper.
However I have just printed out a phone case and realised the holes for audio connections are reversed. Looking some more and I think I have my X and Y wired up wrong.
So if I just swap the connections on the board is the printer going to forgive me for this silly mistake or am I going to run into more issues/problems? I see someone else mention one axis printing the wrong way but changing the coding and endstop fixed this.
I have my endstops in the right place (going by a picture of the thing, at the back with the Y axis motor and near the left with all the electronics and motor for the X bit.
And yes I know I am an idiot...