MendelMax 1.5, what software are you using ?

Hi,

I have bought a used MendelMax1.5, so the only firmware I have is the compiled version on the Arduino.

So I need to start all over, what software is currently recommended, or are you using ?

And is there a commissioning guide somewhere, I can not find one.

Thank you,

I read the log on Printrun, and it seems to have all the configuration for my printer, and it was using Marlin 1.0.0.

So I guess I just compile the latest version of Marlin, with my machine parameters ?

Thank you,


echo: External Reset
Marlin 1.0.0
echo: Last Updated: Apr 24 2014 17:37:47 | Author: (none, default config)
Compiled: Apr 24 2014
echo: Free Memory: 4512 PlannerBufferBytes: 1232
echotored settings retreived:
echoteps per unit:
echo: M92 X80.00 Y80.00 Z1600.00 E900.00
echo:Maximum feedrates (mm/s):
echo: M203 X500.00 Y500.00 Z5.00 E45.00
echo:Maximum Acceleration (mm/s2):
echo: M201 X9000 Y9000 Z100 E10000
echo:Acceleration: S=acceleration, T=retract acceleration
echo: M204 S3000.00 T3000.00
echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum xY jerk (mm/s), Z=maximum Z jerk (mm/s)
echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00
echo:Home offset (mm):
echo: M206 X0.00 Y0.00 Z0.00
echoID settings:
echo: M301 P22.20 I1.08 D114.00
echoD card ok
SENDING:M105
ok T:19.0 /0.0 B:21.8 /0.0 @:0 B@:0