Bought a used MedelMax1.5
Posted by Walther
|
Bought a used MedelMax1.5 July 25, 2014 05:30AM |
Hi,
New to the forum and 3D printing,..
I just bought a used MendelMax1,5 with only 2m of 3mm PLA.
So i need to buy PLA to get started.
Should I continue with 3mm or switch to 1.75mm ?
It should be able to take both, although I have not found a manual yet (I have a reduction tube)
Sorry for asking such a noob question.
Thank you,
New to the forum and 3D printing,..
I just bought a used MendelMax1,5 with only 2m of 3mm PLA.
So i need to buy PLA to get started.
Should I continue with 3mm or switch to 1.75mm ?
It should be able to take both, although I have not found a manual yet (I have a reduction tube)
Sorry for asking such a noob question.
Thank you,
|
Re: Bought a used MedelMax1.5 July 31, 2014 12:52PM |
Hi again,
I had some problems printing on my new/old printer, and I thought it was related to the filament.
But when I took the extruder apart, it looks like a bearing had been overtightened, and taken the extruder apart.
Is there no spacer preventing the bearing in the image from twisting inwards ?
And do I need a new printed part, it looks a bit battered.
Thank you,
I had some problems printing on my new/old printer, and I thought it was related to the filament.
But when I took the extruder apart, it looks like a bearing had been overtightened, and taken the extruder apart.
Is there no spacer preventing the bearing in the image from twisting inwards ?
And do I need a new printed part, it looks a bit battered.
Thank you,
|
Re: Bought a used MedelMax1.5 August 10, 2014 05:16AM |
hello, personaly to avoid your problem I use another nuts between the wheel and the wade.
Sorry, only registered users may post in this forum.