Welcome! Log In Create A New Profile

Replaced thermistors but no effect still same error

bensteffen

Replaced thermistors but no effect still same error
June 11, 2014 09:24AM

Registered: 9 years ago
Posts: 5

Recently i posted about i accidentally shortened my Mendel Prusa 2 by one of its thermistors. I replaced both but this had sadly no effect at all... Anyone a idea how to fix this problem? The heater-thermistor gives a themperature of 220 celcius, the bed 218 (maximum). I have a Ganguinolalu board version 1.3a

I need to fix this quick, because of some prints i need to make this week.

Thnx in advance.

Reply Quote

Anonymous User

Re: Replaced thermistors but no effect still same error
June 11, 2014 06:46PM

Hi,

Did you try to "re-flash" your board? What kind of firmware are you using? Also, are the new thermistors exactly like the old ones you blew out?

While you're at it, please post the config.h here. Thanks.

Romel

Reply Quote

bensteffen

Re: Replaced thermistors but no effect still same error
June 12, 2014 05:35AM

Registered: 9 years ago
Posts: 5

Hi,

I used the following firmware;

[github.com]

Flashing the board initiated to several errors during upload with Arduino, i think that the board is really broken. I tried it serveral times, also using the reset button.

Ben

Reply Quote

Anonymous User

Re: Replaced thermistors but no effect still same error
June 12, 2014 05:37PM

What errors are showing? Can you provide a screen shot perhaps? Also, what version of the Arduino IDE are you using?