Welcome! Log In Create A New Profile

Advanced

Z-axis not homing

Posted by jpt000 
Forum List Message List New Topic
jpt000
Z-axis not homing
May 23, 2014 07:53PM
Hi all,
I am having some weird problems with my Prusa i3. All my axes seem to move fine. X and Y home fine. Z moves up and down just fine, but when I press the home button it makes a weird noise and doesn't move. I am using the latest Repetier firmware with a RAMPS 1.4 setup.
Any ideas?
Cheers
Reply Quote
sdavi
Re: Z-axis not homing
May 24, 2014 12:17AM
Sounds like the max feedrate for z-axis is too high. Try lowering it until it works, usually around 2-4mm/s is common for i3.
Reply Quote
jpt000
Re: Z-axis not homing
May 25, 2014 02:31PM
That was it± Thanks!!!
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login