Hey All,
I decided to build a PRUSA i3
as a novice to both mechanical and electrical > the build went very well. I am also very amped to print.
I am stuck - I'm looking for knowledgeable people to provide a Troubleshooting list I can run through .
ISSUE > My Motors are "shuddering" and making sounds no 3d Printer should make
Too little or too much current ? - i have changed the current on the ramps board both ways - did not resolve the issue.
if you have any ideas, please let me know.
i will recheck the wiring + connectors
thank you
Edited 2 time(s). Last edit at 04/29/2014 03:19PM by KG1610.