Hi all! I was hoping to get some feedback on my most recent test cube. This cube is printed in clear 3mm PLA using a .50 JHead. 0% infill, .4/.35 layer height, 185/185 extrusion temp, 60/60 bed temp. I spent all day yesterday replacing both belts and calibrating the e-steps following Zennmaster's directions on his YouTube video. This cube actually looks a lot better than the first few cubes I've done over the last few days, but there are still some issues and I want to get them sorted and fixed so I can start printing Kossel Mini parts. Any and all suggestions are greatly appreciated!
Here are a couple pictures as well as a short video I made. I think I hear something rattling on the x-axis, but I can't identify the source. [
www.dropbox.com]
Thanks!
(Oh, printing on a MakerFarm 6" Prusa i3)
