HI All.
So I have just finished my I3 build and no i am up the electronics.
I have edited the merlin FW to specify the Ramps 1.4 as my board and to specify the HotEnd thermistor...
I have tested in Pronterface I can connect to the printer. I can move in all axis X, Y and Z. Forward and Back no problems.
My question is All my Max/Min values are off on all axis. meaning the X-axis would be in the middle and i cant move it and farther because it has recognised that as a MIN. This is happening on all axis.
Is there a methodical approach that i can follow to calibrate all axis. My end stops of homing are left on X and REAR on Y, but I am not sure if I need to specify end stops in Marlin or not.
I have been looking for a document on calibration but I have yet to find one.
Any-help will be greatly appreciated.