Welcome! Log In Create A New Profile

Advanced

Help with Endstops and Calibration ( i2 )

Posted by lnw67 
Forum List Message List New Topic
lnw67
Help with Endstops and Calibration ( i2 )
February 26, 2014 03:04PM
Hello first time builder, I am almost finished with my first printer and I am trying to figure out if anyone can help with the following.

How do I set the zero position for my printer? I am using the sprinter firmware.

Is it possible to add an extra endstop?

Thank you!
Reply Quote
waitaki
Re: Help with Endstops and Calibration ( i2 )
February 27, 2014 04:39AM
Are you talking about the Z home position?

_______________________________________
Waitaki 3D Printer
Reply Quote
lnw67
Re: Help with Endstops and Calibration ( i2 )
February 27, 2014 06:59AM
I am trying home x,y, and z position.
Reply Quote
waitaki
Re: Help with Endstops and Calibration ( i2 )
February 28, 2014 05:30AM
[reprap.org]

_______________________________________
Waitaki 3D Printer
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login