Welcome! Log In Create A New Profile

Pronterface Connection Problem

Posted by jsluke

jsluke

Pronterface Connection Problem
February 22, 2014 09:38AM

Registered: 10 years ago
Posts: 44

I'm commissioning my Prusa Mendel i2.

I am using Ramps 1.4 with an Arduino Mega 2560 and Marlin v1 firmware.

The firmware builds in the Arduino dev environment and I can upload to the Mega board without a problem.

When I press connect in Pronterface I get a load of strange text =>

Screenshot.jpg

Any ideas?

Thanks.

James.

Reply Quote

sjerguy

Re: Pronterface Connection Problem
February 22, 2014 09:45AM

Registered: 10 years ago
Posts: 47

Wrong baud rate.

Let me correct that - Baud Rate doesn't match the baud rate set in marlin!

I am using the highest baud rate on my i3xl.

Which I'm guessing would mean you have to change your marlin setting.

Reply Quote

jsluke

Re: Pronterface Connection Problem
February 22, 2014 09:57AM

Registered: 10 years ago
Posts: 44

That's fixed the problem - the baud rate in config.h was set to a different value to my port configuration - now working.

Many thanks.

James.