End stop question (mendel v2) February 15, 2014 05:30AM |
Registered: 10 years ago Posts: 91 |
Re: End stop question (mendel v2) February 15, 2014 02:03PM |
Registered: 10 years ago Posts: 91 |
Re: End stop question (mendel v2) February 15, 2014 11:41PM |
Registered: 10 years ago Posts: 211 |
Re: End stop question (mendel v2) February 16, 2014 04:19AM |
Registered: 11 years ago Posts: 1,592 |
Re: End stop question (mendel v2) February 16, 2014 05:41AM |
Registered: 10 years ago Posts: 91 |
Quote
n9jcv
i think the reason it only moves away from the endstop is this.
When you first power on the machine it will only move away from the minimum end stops, because whereever it was powered on it considers the zero point. trying homing the axis then you should be able to move both ways
b
Re: End stop question (mendel v2) February 16, 2014 11:51AM |
Registered: 10 years ago Posts: 211 |
Re: End stop question (mendel v2) February 16, 2014 01:26PM |
Registered: 10 years ago Posts: 91 |
Re: End stop question (mendel v2) February 26, 2014 05:14PM |
Registered: 10 years ago Posts: 18 |
Re: End stop question (mendel v2) February 27, 2014 04:00AM |
Registered: 11 years ago Posts: 1,592 |