Hi! I've been experiencing a fair amount of warping/adhesion issues with printing using ABS. I turned up the temp on the heat bed and the extruder, which helped a lot. But on taller prints, the issues start popping up again--although not as bad as before. I was thinking about adding an acrylic/plexiglass case around the printer (or around most of it) to help keep the heat in and the fluctuating temperature in my apt out. Is there anything I should know or be aware of being doing this? I was going to go to Lowes today and get a couple pieces of acrylic/plexiglass. I can't decide if I should just do 3 sides (around the front) or 4 (including the back) or 5 (including the top.
Thanks!!!