Sending G-code to 3d printer September 30, 2015 05:54AM |
Registered: 8 years ago Posts: 3 |
Re: Sending G-code to 3d printer September 30, 2015 06:51AM |
Admin Registered: 13 years ago Posts: 7,002 |
Re: Sending G-code to 3d printer September 30, 2015 07:11AM |
Registered: 10 years ago Posts: 14,672 |
Quote
Dust
Some firmwares require you to wait for the OK before the next line.
Re: Sending G-code to 3d printer September 30, 2015 10:10PM |
Registered: 9 years ago Posts: 978 |
Quote
hyabc12321
Hello,
I'm trying to write a program to control my printer.
It seems that simplily sending g code string via serial port will not work.
Is there any solution for this problem?
THX
Re: Sending G-code to 3d printer October 01, 2015 03:05AM |
Registered: 8 years ago Posts: 3 |
Quote
frankvdh
This is just way too vague to get a useful answer.
What type of printer do you have? What type of firmware is installed on it? Or are you wanting to write the firmware yourself? What hardware interface are you using?
Have you had the printer working with other software? e.g. Repetier Host, Octoprint.
Re: Sending G-code to 3d printer October 01, 2015 04:50AM |
Registered: 9 years ago Posts: 978 |
Re: Sending G-code to 3d printer October 04, 2015 04:35AM |
Registered: 8 years ago Posts: 3 |
Re: Sending G-code to 3d printer October 04, 2015 04:47AM |
Registered: 10 years ago Posts: 550 |
Re: Sending G-code to 3d printer February 03, 2017 10:41AM |
Registered: 7 years ago Posts: 1 |
Re: Sending G-code to 3d printer February 04, 2017 09:37PM |
Registered: 11 years ago Posts: 1,049 |
Re: Sending G-code to 3d printer March 06, 2017 04:07PM |
Registered: 7 years ago Posts: 14 |