hi,
i have a MKS Base V1.0 board and i have two socket exp 1 and exp 2, my problem is that my display screen is evolution of full graphic smart controller and wiring is diferent of this one.
for exemple the full graphic smart controller (original) is connected on the interface panel with the connector exp 1 and exp 2 and this interface panel is connected on the aux 3 and aux 4 on the ramps 1.4.
my smart controller is connected directly on the aux 2 and aux 3 on the ramps 1.4 board and i search how change the pins in the repetier firmware.
thanks and best regards.
