Arduino IDE falling across it's own feet November 09, 2012 01:23PM |
Registered: 13 years ago Posts: 7,616 |
core.a(main.cpp.o): In function `main': C:\Users\...\arduino-1.0.1\hardware\Gen7\cores\arduino/main.cpp:11: undefined reference to `setup' C:\Users\...\arduino-1.0.1\hardware\Gen7\cores\arduino/main.cpp:14: undefined reference to `loop'What's happening is pretty clear: Arduino IDE doesn't see the main() in mendel.c, but the main() in it's own library instead. Has somebody else seen this and perhaps found a way around this behaviour?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Arduino IDE falling across it's own feet November 10, 2012 09:41AM |
Registered: 11 years ago Posts: 62 |
Re: Arduino IDE falling across it's own feet November 11, 2012 08:29AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Arduino IDE falling across it's own feet December 13, 2012 01:39PM |
Registered: 11 years ago Posts: 56 |
Re: Arduino IDE falling across it's own feet December 13, 2012 01:43PM |
Registered: 11 years ago Posts: 56 |
Re: Arduino IDE falling across it's own feet December 14, 2012 06:33AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Arduino IDE falling across it's own feet August 31, 2014 08:01PM |
Registered: 9 years ago Posts: 2 |
Re: Arduino IDE falling across it's own feet September 01, 2014 03:53AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Arduino IDE falling across it's own feet September 01, 2014 02:13PM |
Registered: 9 years ago Posts: 2 |
Quote
Traumflug
You should follow the "Simple Installation" instructions on the wiki page. Especially the part with renaming the folder properly.