Welcome! Log In Create A New Profile

Advanced

Drifting while printing

Posted by Lucky 
Drifting while printing
September 29, 2012 03:54AM
Hi Friends,

I am new to this reprap forum and 3D printing as well. Just got my new 3d printer, at times it prints fine but at times in the middle it drifts, i mean the next layer does not fall on the previous and it happens at times in x-axis and at times in y-axis, I have checked the belt tightness and also if it is not getting excess supply but both are fine and moreover at times it prints objects just perfect with the same settings. Please Advise......
Re: Drifting while printing
October 04, 2012 12:01PM
Are your stepper drivers well adjusted and enough cooled (fan or heater)? If they are too hot they can miss steps, this could explain your drifting issue…

Your question should be asked into printing thread I think… winking smiley


François

[reprapide.fr]
Re: Drifting while printing
November 14, 2012 05:31PM
I had this happen when the filament was putting tension on the movement of the extruder by pulling on it. A physical rather than electronic problem.
Sorry, only registered users may post in this forum.

Click here to login