Hi
On my Gen6-Mod-Board I exchange the original crystal to one with 18.432 MHz.
This has the effect of matching the perfect data rate without any variations.
[
www.wormfood.net]
That's not necessary. Nearly all user works with little deviance of the baudrate.
And it works fine.
But I want the perfect match to ban future problems.
Before that, I used a crystal with 20MHz and 250000 baud with the RepetierHost-Programm.
Also a perfect match.
Unfortunately this data rate is not supported in mono on Linux.
So I used for Reprap a virtual machine or windows.
Very annoying.
I could use an other baudrate but I don't want to.
Now with 18.432Mhz crystal and 230400 Baud, it works direct under Linux.
I compiled the bootloader from Peter Fleury of Traumflug's github.
who contributes a litte patch.
[
github.com]
I compile it for some MCUs. But I only know for the Atmega644 that it works.
For upload the bootloader see:
http://reprap.org/wiki/Gen7_Board_1.4#Boot_loader_Upload
Edited 3 time(s). Last edit at 07/02/2012 12:05PM by ado.
________________________________________________________________________________
Prusa mit Gen6-Mod und 230V Heizbett mit Solid State Relais
Repetier Host + Repetier FW mit Slic3r
Attachments:
open |
download -
bootloader_stk500v2_18432000_644.hex
(3.2 KB)
open |
download -
bootloader_stk500v2_18432000_644p.hex
(3.2 KB)
open |
download -
bootloader_stk500v2_18432000_1284p.hex
(4.1 KB)
open |
download -
bootloader_stk500v2_18432000_2560.hex
(4.1 KB)