Welcome! Log In Create A New Profile

No re-bump when homing X axis. Marlin 1.1.5 and 1.1.6

Posted by wikolii

wikolii

No re-bump when homing X axis. Marlin 1.1.5 and 1.1.6
December 17, 2017 01:00AM

Registered: 8 years ago
Posts: 4

Homing the x-axis does not trigger the re-bump feature. Y and Z axis work as intended with re-bump
This is causing a lot of problems when trying to recover prints after power loss

Can any1 guide me in the right direction? Thanks in advance

Edited 1 time(s). Last edit at 12/17/2017 01:01AM by wikolii.

Reply Quote

wikolii

Re: No re-bump when homing X axis. Marlin 1.1.5 and 1.1.6
December 18, 2017 11:42PM

Registered: 8 years ago
Posts: 4

New development:

This is only showing on the X axis that is the only one with the endstop configuration set to max (#define X_HOME_DIR 1)
I changed it to min and inverted the X_DIR and the bump feature worked.

Now, my machines all have the X endstop on the max side, and it was working fine in previous versions of marlin ("1.1.0-RC3")
Any ideas?
Thanks!