I for the life of me, can't figure out why the LCD is not working with the current config. I'm using a Melzi V2 board with the 5 key 2004 LCD and the configuration file is attached. I uncommented the Anet_LCD variable and defined it as Analog 1. The old config(which does not work with the latest Merlin anymore) works just fine, but I essentially copied each corresponding value from the old config to the new one, yet the LCD is not working. Anyone have any experience with this? Or if anyone has an updated Melzi config for Tronxy/Zonestar P802MA, that would work as well.
The line I uncommented:
The old config have this uncommented:
But I tried uncommenting that in the new config, but that's not working either.
Edited 6 time(s). Last edit at 09/24/2017 12:39PM by EnumC.