Welcome! Log In Create A New Profile

Advanced

Fan PWM with Teacup and Gen7-ARM

Posted by Fivefold 
Fan PWM with Teacup and Gen7-ARM
July 31, 2017 02:48PM
I am using Gen7-ARM and Teacup and would like to add a PWM-controlled fan to my printer.

I managed to add a new device/fan in the board.h, using one of the SPI pins as output (in my case PIO0_11). This does make the pin controllable via M106 as intended, but unfortunately only as on/off state. There's no PWM, regardless of the respective parameter/setting in the board.h. I am not sure how the PWM is implemented in the LPC1114 but the extruder heater/ PIO0_10 pin is using pwm, so the functionality should be there.
Is there an easy way to do this or would I need to code my own solution?
Re: Fan PWM with Teacup and Gen7-ARM
August 01, 2017 02:32PM
The timer from PIO0_11 is CT32B0. And this is the timer for the stepper. So you have 2 options. Use another pin with available pwm or you can try the experimental branch which has software pwm.


Triffid Hunter's Calibration Guide --> X <-- Drill for new Monitor Most important Gcode.
Re: Fan PWM with Teacup and Gen7-ARM
August 03, 2017 03:36AM
I didn't think of trying a different pin. PIO0_9 works perfectly.
Sorry, only registered users may post in this forum.

Click here to login