Quote
Dust
what does #define Z_MIN_POS say in your config?
Config.h
#define Z_MIN_POS 0
I've tried setting the minimum position at -2.5. It appears not to have to do with the final homed position. When MIN_POS is less than 0 it seems to move past the point when the limit switch is triggered and still completes homing in the same position.
I've considered creating a custom gcode start for this machine. not sure if it will work though. The gcode reads correctly and when I look at the commands in Repetier-Host it appears to be executing correctly.
When the machine is moving up after triggering the limit switch it appears to me making two different moves in Z. Like a short deceleration/acceleration.
Any help would be greatly appreciated.