Can't figure out where to put Azteeg Sanguino addons so they're recognized by Arduino 1.6.12 October 12, 2016 02:12PM |
Registered: 12 years ago Posts: 411 |
In file included from sketch/pins_AZTEEG_X1.h:30:0, from sketch/pins.h:87, from sketch/MarlinConfig.h:33, from ~/Documents/3D_printing/Sketchbooks/Marlin-1.1.0-RC7-Azteeg-Blue-MendelMax/Marlin-1.1.0-RC7-Azteeg-Blue-MendelMax.ino:37: pins_SANGUINOLOLU_11.h:28: error: #error "Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu." #error "Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu." ^ exit status 1 #error "Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu."
#if !defined(__AVR_ATmega644P__) && !defined(__AVR_ATmega1284P__) #error "Oops! Make sure you have 'Sanguino' selected from the 'Tools -> Boards' menu." #endif
Re: Can't figure out where to put Azteeg Sanguino addons so they're recognized by Arduino 1.6.12 October 13, 2016 02:50AM |
Admin Registered: 13 years ago Posts: 6,995 |
Re: Can't figure out where to put Azteeg Sanguino addons so they're recognized by Arduino 1.6.12 October 13, 2016 09:36AM |
Registered: 12 years ago Posts: 411 |
Quote
Dust
I just replicated your install without #6, got the same error. (missed something obvious)
The issue is that you need to select the correct processor, you have a ATmega644 selected
This is invalid, it needs to be a ATmega644p or ATmega1284p
(ATmega 1284P on v1.5, ATmega 644P on v1.0 on a Azteeg X1)