Firmware Version: 1.09r-dc42 (2016-01-16)
Web Interface Version: HTML: 1.08, JS: 1.08
because of this:
post
I did the following remap:
M563 P0 D0 H1 ; tool 0 uses extruder drive 0 and heater 1
M563 P1 D5 H2 ; tool 1 uses extruder drive 5 and heater 2
M563 P2 D2 H3 ; tool 2 uses extruder drive 2 and heater 3
M563 P3 D4 H4 ; tool 3 uses extruder drive 4 and heater 4
omitting D1 and D3, they are sadly broken.
But now the web interface shows in Print Status -> Extrusion Factors:
Extruder 1, Extruder 2, Extruder 3, Extruder 4, Extruder 5, Extruder 5
notice the double Extruder 5 at the end and also in Machine Status->Extruder Drives:
D1, D2, D3, D4, D5, D6
But D1 and D3 is not configured anywhere in the config.g.
Is there anyway I can get this working correctly?
Maybe thru M569 remapping?
