Post your favorite config... pin it.
Posted by Oz Stevens
|
Post your favorite config... pin it. December 31, 2015 04:09AM |
In order to help folks better tune their machines, could we get a PINNED post that only contains peoples machine data and the actual firmware configuration parameters they use? It doesn't help as much to read people's experiences with Marlin or Slic3r, etc., as it does to let people see settings that have produced great results.
There are basically 4 'styles' of Fused Deposition Modelling (FDM) or Fused Filament Fabrication (FFF) or Plastic Jet Printing (PJP) machines: Cartesian, Delta, SCARA and Polar with a zillion variations. So to best understand what people have had success using, the actual config info would be a tremendous help. Even if the parameters are slightly different for each machine, the minor changes could be the answer to long running headaches.
The forum Topic could be, "My Machine and Configuration". No off topic or bunny trail posts permitted, etc.
Thoughts?
Oz
There are basically 4 'styles' of Fused Deposition Modelling (FDM) or Fused Filament Fabrication (FFF) or Plastic Jet Printing (PJP) machines: Cartesian, Delta, SCARA and Polar with a zillion variations. So to best understand what people have had success using, the actual config info would be a tremendous help. Even if the parameters are slightly different for each machine, the minor changes could be the answer to long running headaches.
The forum Topic could be, "My Machine and Configuration". No off topic or bunny trail posts permitted, etc.
Thoughts?
Oz
Sorry, only registered users may post in this forum.