My Prusa I3 is working fine with a servo driven plunger Z-end stop opto switch. My but I have two annoying issues I would like to correct but I am unsure where to find these settings in marlin.
Issue #1 - When I enabled Auto Bed Leveling I added a G29 to my startup G-code, the printer runs the the ABS routine as soon as I launch the job through the SD card. and then the ABS routine runs again as soon as the bed gets up to temp. How do I start that first ABS routine from running so it only runs after the bed gets up to temp?
Issue #2 - The Z-homing process is soo slow ... First it takes a reading and then takes another reading even slower.. Can I limit it to just one reading at each stop, or can I adjust the decent speed of the Z axis?