Welcome! Log In Create A New Profile

g-code comments are necessary

Tester500

g-code comments are necessary
December 21, 2015 02:39AM

Registered: 8 years ago
Posts: 2

Repetier-host software send to printer command "M105 *1",reprap G-code wiki specifies parameters Snnn, Rnnn. What is the parameter "*n"?

Reply Quote

Tester500

Re: g-code comments are necessary
December 21, 2015 03:06AM

Registered: 8 years ago
Posts: 2

I found - this checksum

Reply Quote

o_lampe

Re: g-code comments are necessary
December 21, 2015 04:12AM

Registered: 8 years ago
Posts: 5,232

"nnn" usually is a placeholder for a ( 3 digit ) number.
Depending on the type of variable, it is often limited between 0-255, because this is what an 8-bit variable can contain.
-Olaf