Welcome!
Log In
Create A New Profile
Home
>
Firmware Folder
>
Firmware - mainstream and related support
> Topic
Advanced
g-code comments are necessary
Posted by
Tester500
Forum List
Message List
New Topic
Tester500
g-code comments are necessary
December 21, 2015 02:39AM
Registered: 8 years ago
Posts: 2
Repetier-host
software send to printer command "
M105 *1
",reprap
G-code wiki
specifies parameters
Snnn, Rnnn
. What is the parameter "
*n
"?
Reply
Quote
Tester500
Re: g-code comments are necessary
December 21, 2015 03:06AM
Registered: 8 years ago
Posts: 2
I found - this
checksum
Reply
Quote
o_lampe
Re: g-code comments are necessary
December 21, 2015 04:12AM
Registered: 8 years ago
Posts: 5,232
"nnn" usually is a placeholder for a ( 3 digit ) number.
Depending on the type of variable, it is often limited between 0-255, because this is what an 8-bit variable can contain.
-Olaf
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login