Hello.
I bought a Fan Extender and like suggested, I connected it to D6 and D11.
Now it turns out that for some reason I can use M42 to change the PWM value for D6, but I cannot use it on pin D11.
I tried 255 as a value for D11 and that DID work, so the problem is that I can't use it as a PWM pin, but only as a digital one.
There was a whole conversation about this, where
THIS reply helped me a lot!
Switching to D4 and D5 fixes that problem.
Both D4 and D5 can now be controlled without any problem, but the switching frequency is back to standard.
When using D6 and D11 I could #define FAST_PWM_FAN to make the fans silent but when I use D4 and D5 it does not do that anymore :/
Any ideas?
Edited 1 time(s). Last edit at 12/11/2015 01:00PM by FalloutBe.
