Was having a problem where my settings (acceleration , Max velocity etc) where different in firmware and on the LCD.
I edited the original question by mistake instead of posting a reply. Heres what I found:
You have to go into configurationstore.cpp and increment the version number:
// IMPORTANT: Whenever there are changes made to the variables stored in EEPROM
// in the functions below, also increment the version number. This makes sure that
// the default values are used whenever there is a change to the data, to prevent
// wrong data being written to the variables.
// ALSO: always make sure the variables in the Store and retrieve sections are in the same order.
#define EEPROM_VERSION "V14"
Noticed that none of the changes I was making were being applied until I did this.
Edited 1 time(s). Last edit at 06/07/2015 02:41PM by wes1007.