Hi, I am asking this here before I make any suggestions on the Marlin github as my issue may already have been addressed and I am missing it.
I recently switched from using a host software (Repetier) to printing directly from SD card, last night I ran a very long print so I left it overnight, this morning the print was complete but I noticed that the heated bed was still hot. Looking at the GCode that Slic3r generated I saw that it only had the code to switch off the extruder and not the bed. I am ok with putting this into Slic3r but I would like the added failsafe within Marlin.
Is there any support already in Marlin to switch off all the heaters when the print is completed? I have looked through the various configuration header files but I cant see anything.
Thanks
Anthony
** I realise that I double posted this, earlier I posted it in the experimental firmware forum, I apologize for this, if the mods could remove it that would be great.