Hi,
i had problem with my mendel prusa since day 1. i have been going through every thing with different result, but haven't been able to finish one print. sometimes it get's broken in the beginning, other in the middle.
i had the idea of buying a infrared temperature measurement tool, and i discovered that the temperature reported by Sprinter, showed in pronterface as C is actually F.
that means that when i set the extrusion to 250 C in slic3r, it shows 250 C in pronterface but when i measure it, is 80C - 100C and 250 F
have this extruder: [
www.dx.com]
so i'm not sure what thermistor has, i tried 100K, 200K and mendel prusa parts options in the configuration.h but also the heatbed has the same behavior so i suppose i need to modify something else and not that.
Could someone give me some tip of where i should look at? i'm using ramps 1.4 btw.
Thanks !