Cura: "pause @ z " error?
Posted by o_lampe
|
Cura: "pause @ z " error? May 30, 2015 03:55AM |
Hi guys,
I sliced a herringbone gear with Cura and added two "pause @ z" sessions at 5.6mm and 6.4mm. I wanted to change filament color that way, since I only have one extruder.
The problem is, once the printer triggered the first pause, the extruder lifts up and parks somewhere ( 0,0 ?) But the lift of the 1st pause already triggers the 2nd pause.
When I noticed, that the second pause was overdue, I used the smart-LCD to manually change filament, but the symetry was gone...
It should be rewritten to ignore z-position while parking the extruder.
-Olaf
I sliced a herringbone gear with Cura and added two "pause @ z" sessions at 5.6mm and 6.4mm. I wanted to change filament color that way, since I only have one extruder.
The problem is, once the printer triggered the first pause, the extruder lifts up and parks somewhere ( 0,0 ?) But the lift of the 1st pause already triggers the 2nd pause.
When I noticed, that the second pause was overdue, I used the smart-LCD to manually change filament, but the symetry was gone...
It should be rewritten to ignore z-position while parking the extruder.
-Olaf
Sorry, only registered users may post in this forum.