when i try to level my delta (manual, no z-probe yet), i found out that after moving to a position, the printer disables the x and y motors but leaves the z-motor powered, well ...since its a delta, it is tower a and b that get switched off but tower 3 stays on.
this means, that when i try to level the delta and move the head to tower a or b, once the printer reached the position, the head sags down a bit because it immediatley stops powering the stepper motor. i can freely move the motors on tower a and b with my hand, but the carriage on tower c is still in perfect position and i cannot move it with my hands beacuse the motor is still powered and holding position.
this is on repetier 0.92
it seems to me that this is the behaviour of a standard cartesian printer because on these printers it makes sense to only keep the z axis powered once the position is reached.
any ideas how to solve this?