Printer will NOT boot! Help Please
Posted by Credo
|
Printer will NOT boot! Help Please April 30, 2015 05:33PM |
Hello everyone,
I'm reaching out to anyone who might be able to help:
I have a rapide lite 200 that's just died on me. Halfway through a print, my extruder fan stopped. I killed the print job, disconnected my printer, rebooted it, now it won't come back. At all.
It's running Marlin based Firmware on a RUMBA (Mega 2560 chipset). I've tried connecting and uploading the factory sketch from the company Rapide 3D, however I'm unable to even connect to the board in order to push the sketch. When I powered on the machine, the power light comes on, and the LED 1 by the reset button blinks twice. After that, nothing. I'm unable to communicate with the board at all.
Can anyone please help offering some insight into my problem? I will provide any information required. Please help.
Thank you very much in advance.
I'm reaching out to anyone who might be able to help:
I have a rapide lite 200 that's just died on me. Halfway through a print, my extruder fan stopped. I killed the print job, disconnected my printer, rebooted it, now it won't come back. At all.
It's running Marlin based Firmware on a RUMBA (Mega 2560 chipset). I've tried connecting and uploading the factory sketch from the company Rapide 3D, however I'm unable to even connect to the board in order to push the sketch. When I powered on the machine, the power light comes on, and the LED 1 by the reset button blinks twice. After that, nothing. I'm unable to communicate with the board at all.
Can anyone please help offering some insight into my problem? I will provide any information required. Please help.
Thank you very much in advance.
Sorry, only registered users may post in this forum.