Welcome! Log In Create A New Profile

How can i set the Home/Park Position?

Posted by DFix1

DFix1

How can i set the Home/Park Position?
February 21, 2015 09:02AM

Registered: 9 years ago
Posts: 324

Is Home Position and Park Position the same?

I turn on the Printer and select in the lcd menu "Auto Home". My printer drives in the lower left Corner. This is the position i mean.

i want to change this position a little bit. x+10 and y +10
how can i do that?

In the configuration.h i have changed this:

#define MANUAL_X_HOME_POS 10
#define MANUAL_Y_HOME_POS 10

But the printer goes to the same position as before.

.-=cU. Pascal=-.
────────────
Prusa i3 Hephestos + Simplify3d
BMG-Vollmetall-Extruder 1,75 mm/0,4 mm Düse
Ramps 1.4

Reply Quote

0backbone0

Re: How can i set the Home/Park Position?
February 23, 2015 07:34AM

Registered: 10 years ago
Posts: 39

Hi,

did you uncommented this Line?

//#define MANUAL_HOME_POSITIONS // If defined, MANUAL_*_HOME_POS below will be used

If not then the Values for Manual Homing are ignored, i belive. I could be wrong, but its simple to test out.

Reply Quote

DFix1

Re: How can i set the Home/Park Position?
February 23, 2015 07:45AM

Registered: 9 years ago
Posts: 324

Damn! The solution was so simple smiling bouncing smiley

Thanks

.-=cU. Pascal=-.
────────────
Prusa i3 Hephestos + Simplify3d
BMG-Vollmetall-Extruder 1,75 mm/0,4 mm Düse
Ramps 1.4