Well after solving many other problems I am now at this one. I am using ramps 1.4 heated bed all on a pruas i3 rework.
Problem is when I load the test print 20mm cube and prease print the bed moves all the to the max and the extruder moves al the way to the max witch puts it in the bottom right corner.
Now by the way it looks it is not even getting to print the full 20mm , its only around 10mm. I have gone through the firmware and slicer and can not find anything wrong, but I am also new so.
I am using Marlin firm wear. .
Also when I am just moving everything with pronterface things move the way they are suppose to and to the limits that are set.