Welcome! Log In Create A New Profile

Need help, new image needed for Rapman, Pic32 chip.

Posted by AlfrdV

AlfrdV

Need help, new image needed for Rapman, Pic32 chip.
July 11, 2014 01:58PM

Registered: 9 years ago
Posts: 4

Hello,

I am busy with a Rapman from BfB. But have not much luck.
The software in the pic is corrupt. I cannot connect through the usb port.
So i am looking for a hex file with all data to let the rapman run again. I have
The PicKit2 to program the chip.
I have the Rapman 3.2 with a pcb V 3.4.
Thanks.

Alfred

Edited 2 time(s). Last edit at 07/12/2014 05:01PM by AlfrdV.

Reply Quote

Traumflug

Re: Need help, new image for Pic32 chip from Rapman
July 12, 2014 07:15AM

Registered: 13 years ago
Posts: 7,616

You mean BitsfromBytes, the long gone company? And a PIC-based electronics? Didn't even know such a thing existed after the very first Generation 1 Electronics. If you do have such a vintage electronics it might be a good idea to upgrade, at that time fimrwares didn't even do acceleration, much less more modern features.

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Reply Quote

AlfrdV

Re: Need help, new image for Pic32 chip from Rapman
July 12, 2014 09:57AM

Registered: 9 years ago
Posts: 4

Well it could be a older printer but fot me i think it is nice starter. If it should work.:-).
Simple control of the operation.
I have a Gen6 deluxe board that i am already configure to work with the rapman. So if i can't find anything
I switch to de Gen6 board. Hopefully the drivers can hndle the motors.