Hello,
I've built a Prusa Mendel i3, using Marlin, and all is going well, but I'd like to upgrade it with a dual extruder so I can use support material or dual colors. I was doing some research, and I found a neat hybrid extruder on [
www.thingiverse.com]. I know that Marlin supports dual extruders, but I can't figure out how to use a different steps per mm value for each of the extruders (I'm planning on using a direct drive bowden extruder for the 2nd hotend). Is there any workaround/solution in Marlin or Slic3r that I can use?
Thanks!
